LALJI IMPEX

Pypkote 4 mm is a Pipeline Corrosion Resistant Tape conforming to IS 10221 Appendix B specification. It comprises of a Tar based Polymeric mix supported on a fabric of high tensile strength Fibreglass. The Polymeric mix is specially manufactured to have properties of high softening point, high penetration and high resistance to ageing. Tape is terminated on both exteriors by thermofusible HMHDPE Film which aids in the installation process. Application is fast and easy. The pipe surface is first cleaned with a wire brush. IWL CS is applied on pipes immediately after cleaning. This is to prevent any further accumulation of rust on the pipe. After the primer is applied on the pipe, it is allowed to dry for about 30 minutes till it becomes touch dry. Before adhering the tape to the pipe, it is advisable to gently heat the primer coated pipe by a run of LPG torch. The bottom surface of the tape is heated by LPG Torch or any heat source. The tape is wrapped either by spiral or circumference method over the pipe. By heating the primer coated pipe and by removing the bottom polyethylene from the tape before wrapping, better adhesion between the tape and pipe is obtained. Overlaps are maintained with a minimum of 12 mm. Afinal coat of White Wash is done immediately over the entire coated pipe. Over weld joints, the tape is applied after the necessary welding and testing of the joints are completed. The procedure for application of tape is the same as bare pipe procedure. Overlaps on each side of the weld joints are to be 50 mm. Pypkote tape is recommended for application closer to the time of pipe erection and lowering inside trenches to avoid damages to Pypkote. While in storage, Pypkote Rolls must be stacked properly under cover.

Oil-based primer means that the base of the primer is oil. This primer can be used in combination with oil-based paint. Oil-based primer is better at sealing in stains and tannins. So, if you have a nasty smoke stain or smell that you'd like to cover, oil-based primer is ideal.

Our Wrapping Coating Roll Tape (Pykote) is a versatile, self-adhesive tape used for corrosion protection, insulation, and waterproofing of pipes, valves, and fittings.

(I) IWL Coldstick W is a water based primer that can fill substrate pores and its used for waterproofing and pipe coating systems.
(II) Coldstick W is a water based primer that can fill substrate pores and its used for waterproofing and pipe coating systems.

1M*10M

SBS membrane

2/3/4MM

SBS membrane

1M*20M

1M*10M

1M*20M

1M*10M